Page 1 of 1

Cutting hardboard

Posted: Wed Mar 21, 2018 9:48 pm
by Michael S.
Hi everyone,
I am looking to cut some hardboard and was wondering what everyone uses to cut it. I tried a small hand saw and it is taking forever. Thank you for any help!
Michael

Re: Cutting hardboard

Posted: Thu Mar 22, 2018 4:31 pm
by Eilif
For making Hardboard bases I use a coping saw. It's pretty coarse, but cuts quick. Then I shape the edges with a dremel 543 cutting shaping wheel which is the same wheel I use for almost all my toybashing cutting and shaping.

For long strait cuts I recommend a table saw or rotary saw.

Re: Cutting hardboard

Posted: Fri Mar 23, 2018 3:57 am
by Michael S.
Hi Karl,
Thank you for the reply. I had to look up a coping saw and saw that I have one:) I broke the blade years ago, but will pick up a new one. I do not have a dreamal tool, but will try sand paper.
Michael

Re: Cutting hardboard

Posted: Fri Mar 23, 2018 10:11 am
by Eilif
Sandpaper is fine for rounding off the edges. Good Luck!